FUTURA LAMP LED ALL IN ONE

technical data

• 30 UV LED
• Maximum consumption: 48W
• Charger/Power Supply: Input: 100-240V 5 /60Hz 1A - Output: DC 24V 1.5A
• Dimensions (W x H x D): approx. 15cmx19cmx8.5cm
• Radiation data: 365nm + 405nm

Parts overview

1. On/Off button, 120 sec. Soft function:  24W/48W (hold for 2 seconds)

2. Timer: 5 seconds

3. Timer: 30 seconds

4. Timer: 60 seconds

5. Power sensor

6. Adapter

Product information

The Aretini UV curing device is for professional use.  It cures all conventional nail gels (UV Gel, LED Gel, Hybrid Gel and Soak Off).

Safety guidelines

1. Please read the instructions carefully before first use.

2. Please pay attention to a correct mains voltage.

3. Please make sure that no kind of liquids penetrate into the interior of the device. Electrical damage or short circuits can be the result.

4. The device may no longer be used in the event of obvious damage to the associated parts (including power supply unit)

5. The device may be used in the event of any defect, such as  a defect of the timer, no longer be used.

6. If the device is not in use, disconnect the charger from the power supply.

Operating Instructions - Getting started

1. Connect the adapter to the power supply, hardener and circuit.

2. Press the timer button.  The lamp starts to light up. Press the ON / OFF button to turn off the lamp.

3. Holding down the ON/OFF button for 2 seconds halves the power from 48W to 24W. Holding the button again for 2 seconds will double the performance again.

4. If the curing device is switched on, the respective time button can be pressed.

5. If no time button has been activated, the device will cure for up to 120 seconds.

6. The integrated fan has a follow-up time of approx. 30 seconds.